Installing the differential into the clutch housing (Mazda 6 GG)

Install the differential into the clutch housing, install the bearing race and the special device (selector) onto the differential. Install the special devices (selectors) for the primary and secondary shafts into the clutch housing.

Fig. 3.56. Installing the primary and secondary shafts into the clutch housing

Install the shafts with gears as shown in Figure 3.56.

Fig. 3.57. Installation of a special device

[The original article is on: Mazbook.ru]

Install the special device (bushings) in the positions shown in Figure 3.57.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Mechanical gearbox

Adjusting the bearing preload
Assembling a cylindrical pin
Installing the pinion bearings
Differential assembly components
Checking the primary shaft elements

Installing the main gear housing
Elimination of gaps in the primary, secondary shafts and differential…
Measuring the load on the primary, secondary and differential shafts…

More articles on repairing other Mazda models
Replacing the driven disc or clutch housing Mazda Familia 5 (1985-1989)
Installing lumbar support Mazda Capella 3 (1982-1992, petrol)
Installing the differential into the clutch housing Mazda3 BK (2003-2009)
Installing the engine assembly Mazda CX-5KE (2012-2017)
Installing a timing belt Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)