Remove the trunk trim.
Remove the fasteners and slightly bend the side trim of the trunk (right)
Remove the fasteners and slightly bend the side trim of the trunk. (left) (4SD)
Remove the cover of the technological hole. (left) (5HB)
Remove the rear combination light.
Disconnect the license plate light connector.
Fig. 8.15. Removing the rear bumper: 1 – screw A; 2 – screw B; 3 – screw C; 4 – connector A; 5 – bolt A; 6 – connector B; 7 – rear bumper; 8 – reflector; 9 – bolt B; 10 – rear bumper reinforcement
Remove in the order shown in Figure 8.15.
Remove the rear bumper.
Pull back the edges of the rear bumper (wheel niches) outward.
Attach the rear bumper to the body.
Press the rear bumper connectors toward the body to engage them into the bumper locks.
Install in the reverse order of removal.
[The article is copied from the resource MazBook]