Caution: To prevent scratches and damage to the paintwork, apply protective tape to the positions shown in the figure.
1. Disconnect the negative battery terminal.
2. Remove the rear combination lights.
3. Remove fasteners A.
4. Pull the rear fender trim in the direction of the arrow in the figure above, and then turn it back, removing clips B.
Caution: After removing Clips B, insert a rag between the rear fender and the fender liner to prevent damage to the rear fender and Clips B.
5. Remove the rear mudguards.
6. Loosen screws B.
7. Loosen screws C.
8. Remove the D fasteners.
9. Pull the edges of the rear bumper (A) in the direction of the arrow (1) in the figure to detach the strips.
Caution. The rear bumper is firmly attached to the sliders. If the bumper is forcibly separated from the sliders, it may fall and be damaged. Be careful when removing the rear bumper. Take appropriate measures to prevent the rear bumper from falling.
Content based on information from: Mazbook.ru
10. Remove the rear bumper from the sliders.
11. Remove the rear bumper in the direction of the arrow (2) in the figure.
12. Versions with rear fog lights: Disconnect the rear fog light connectors.
13. Versions with parking sensors: disconnect the connectors of the rear ultrasonic sensors.
Caution: After removing the rear bumper, it may hit the fender trim and cause damage and/or injury. Secure the front fender trim with tape.
14. Installation is carried out in the reverse order of removal.
1. Screws.
2. Reflectors (versions without rear fog lights).
3. Rear bumper.