Contents: Front door connector ⇓ Rear door connector ⇓
Attention.
- Removal the door without support may cause it to fall and cause serious injury. Always remove the door with the help of another person to prevent the door from falling.
- After loosening the door limiter mounting bolts, the front door may open before contacting the front fender. This may cause damage to the paintwork of the body. Before removing the door, apply protective tape to the positions shown in the figures. In addition, care must be taken not to damage the doors and front fenders of the car.
1. Disconnect the negative battery terminal.
2. Loosen bolt A of the limiter.
Front door:
1. Bolt A.
2. Connector.
3. Bolts B.
4. Front door.
Back door:
1. Bolt A.
2. Connector.
3. Bolts B.
4. Back door.
3. Disconnect the connector:
Front door connector
Partially bend the rubber cover in the direction of the tab (1) in the figure and remove it from the connector.
Using a flat-head screwdriver wrapped in electrical tape, press the strips A in the direction of the arrows (2) and (3) in the figure and remove the upper part of the connector from the body in the direction of the arrow (4).
Using a flat-head screwdriver wrapped in electrical tape, press the bar B in the direction of the arrows (5) and (6) in the figure and remove the connector from the body in the direction of the arrow (7).
Lower the lever in the direction of the arrow (8) and disconnect the connector in the direction of the arrow (9).
Rear door connector
Press the bar A in the direction of the arrow (1) in the figure and disconnect the connector in the direction of the arrow (2).
4. Loosen the bolts B of the door hinges and remove the door from the vehicle.
5. Installation is carried out in the reverse order of removal.
6. Adjust the position of the door.