Fig. 8.60. Measuring the gap between the sunroof glass and the body
Measure the gap and height between the glass panel and the body (Fig. 8.60).
If the height is not correct, loosen the panel screws and reinstall the glass.
Gap:
- a - 0.8–1.2 mm;
- b - 0 mm.
Tighten the screws.
Fig. 8.61. Checking the tightness of the hatch closure
Insert the card between the seal and the car body. Make sure the hatch is tightly closed (resistance is felt when moving the card) (Fig. 8.61).
If the hatch does not close tightly, adjust its position again.