Removal and installation a security alarm siren (Mazda 6 GG)

Disconnect the negative cable from the battery.

Remove the trunk side trim on the left side.

Fig. 7.76. Removing the security alarm siren: 1 – nut; 2 – connector; 3 – security alarm siren

Unscrew the siren unit mounting nut, disconnect the connector and remove the security alarm siren (Fig. 7.76).

Install in the reverse order of removal.

The article is based on website data www.mazbook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Equipment and devices

Removal and installation the alarm sensor
Relay — purpose and location
Fuses — Description and Replacement
Determining the source of the fault
General information about electrical equipment

Immobilizer — enabling/blocking the key reprogramming function…
Removal and installation the ignition switch
Immobilizer reprogramming procedure
Replacing or registering an additional key
Removal and installation the center panel module

More articles on repairing other Mazda models
F-a2. Wiring diagram for reverse light, turn signals and alarm. Mazda Familia 5 (1985-1989)
Sound alarm system Mazda Capella 3 and 4 (1982-1992)
Security alarm (additional equipment) Mazda3 BK (2003-2009)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)