Removal and installation the alarm sensor (Mazda 6 GG)

Disconnect the negative cable from the battery.

Remove the upholstery.

Disconnect the sensor connector.

Fig. 7.75. Removing the security alarm sensor: 1 – connector; 2 – screw; 3 – security alarm sensor

Loosen the mounting screw and remove the security alarm sensor (Fig. 7.75).

Install in the reverse order of removal.

[The original article is posted on: MAZBOOK.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Equipment and devices

Relay — purpose and location
Fuses — Description and Replacement
Determining the source of the fault
General information about electrical equipment

Removal and installation a security alarm siren
Immobilizer — enabling/blocking the key reprogramming function…
Removal and installation the ignition switch
Immobilizer reprogramming procedure
Replacing or registering an additional key

More articles on repairing other Mazda models
Removal and installation the ignition distributor sensor Mazda Familia 5 (1985-1989)
Replacing the oxygen sensor Mazda Capella 3 (1982-1992, petrol)
Light sensor Mazda3 BK (2003-2009)
Clutch Pedal Position Sensor Mazda CX-5KE (2012-2017)
Removal and installation the fuel pump and fuel quantity sensor Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)