Note. On vehicles equipped with a trip computer, when setting the clock, use the button «INFO» (information) instead of a button «SET» (installation).
Setting the clock
Press and hold the button «CLOCK» (watch), until a short beep sounds. The indicator will light up on the display «12Hr» or «24Нr», corresponding to the 12-hour and 24-hour time indication mode.
Click on the button «SET», to switch between 12-hour and 24-hour time display. The indicator of the selected mode will start flashing.
To select the desired time indication mode, press the button «CLOCK» (watch) again while the selected mode indicator continues to flash.
The indicator will then light up on the display «Hr. ADJUST» (setting the current time - hours), and two left digits (watch) will start flashing. With button «SET» set the required readings of the current time in the two left digits (watch) and then click on the button «CLOCK» (watch).
The indicator will then light up on the display «Min. ADJUST» (setting the current time - minutes), and two right bits (minutes) will start flashing. With button «SET» set the required readings of the current time in the two left digits (watch) and then click on the button «CLOCK» (watch).
Changing the clock
While the current time is being displayed, press the button «SET» and hold it for at least one and a half seconds. When the button is released, a short beep will sound and the clock will change.
For example:
12:01–12:29–12:00
12:30–12:59–1:00
Note. When the button is released «SET» the seconds digits are reset.