Familia Capella Mazda3 Mazda6 CX-? Others Articles

Mazda6 GG (2002-2008)

Removal and installation the speedometer sensor of a car (without anti-lock braking system) (Mazda 6 GG)

0

Disconnect the negative battery cable.

Remove the battery and its tray.

Remove the air filter element.

Disconnect the vehicle speedometer sensor connector.

Remove the vehicle's speedometer sensor.

Apply transmission fluid to the new O-ring and install it onto the vehicle's speedometer sensor.

Install the vehicle speedometer sensor.

Tightening torque: 7.8–11.3 Nm.

Connect the vehicle speedometer sensor connector.

Install the air filter element.

Install the battery and tray.

Connect the negative battery cable.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Previous

Mazda6 GG » Mechanical gearbox

Next

Checking and replacing oil in a manual transmission
General information about manual transmission

Replacing the seal (differential)
Removal and installation the gear shift mechanism
Gear Selector Cable Installation Instructions
Clutch housing, disassembly of main gear housing elements
Checking the primary shaft elements

More articles on repairing other Mazda models
Anti-lock braking system (ABS) Mazda Familia 6 (1989-1994)
Anti-lock braking system (ABS) (since 1987) Mazda Capella 3 and 4 (1982-1992)
Removal and installation the speedometer sensor of a car (without… Mazda3 BK (2003-2009)
Removal and installation the clutch travel sensor Mazda CX-5KE (2012-2017)
Scheme 7. Anti-lock braking system Mazda BT-50 (1) (2006-2011)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)