Ambient air temperature indicator (Mazda 3 BK)

Manual climate control system

The display shows the ambient temperature when the ignition switch is in the "ON" position (ignition on).

Automatic climate control system

If the ignition switch is in the "ON" position (ignition on), to display the ambient temperature readings, press the "AMB" button (ambient air temperature), which is located on the climate control panel. Click on the "AMB" button (ambient air temperature) again to switch the display to the mode of indicating the air temperature in the cabin, which is set for the microclimate control system (Fig. 1.96).

In some cases, the ambient air thermometer readings may differ from the actual air temperature (it depends on the surrounding conditions and the condition of the car):

• very low or high temperature;
• a sharp change in ambient temperature;
• the car is parked;
• the car is moving at low speed.

Automatic climate control system display

The display shows information about the current state of the microclimate control system.

Audio system display

The display shows information about the current state of the audio system.

Trip computer display

The trip computer allows you to monitor the following data on the display:

• current fuel consumption;
• average fuel consumption;
• range of fuel remaining in the tank;
• average speed of the car.

Current fuel consumption

The trip computer display shows the current fuel consumption, which is calculated based on fuel consumption and the distance traveled.

Current fuel consumption is calculated and updated every 2 s.



In the current fuel consumption indication mode, the indicator lights up on the display "CONSUM CUR" (Fig. 1.97).

When the vehicle speed drops to approximately 5 km/h, the current fuel consumption readings are replaced by symbols "–– L/ 100 km".

Average fuel consumption

The trip computer display shows the average fuel consumption, which is calculated taking into account the volume of fuel consumed and the distance traveled by the vehicle since the last time the battery was connected to the on-board network or since the last reset of the trip computer. Average fuel consumption is calculated and updated on the display every minute. In the average fuel consumption display mode, the "CONSUM AV" indicator lights up on the display.





To delete the trip computer readings displayed on the display, press the "INFO" button (information) and hold it down for at least one second. After long pressing the "INFO" button (information) symbols will appear on the display "–– L/ 100 km", which will remain on the display for one minute until a new average fuel consumption value is calculated.

Cruising range based on fuel remaining in the tank (Fig. 1.99).

The display shows the approximate distance the car can travel on the fuel in the tank. The range calculation is based on average fuel consumption.

The fuel range is recalculated and updated every minute.



In the fuel range indication mode, the "REMNG" indicator lights up on the display.

Note: If the trip computer indicates that there is sufficient range until the next refueling, immediately fill the vehicle's fuel tank if the fuel gauge needle is near the "E" (empty) mark or the low fuel indicator lights up.

Note: The trip computer display will not change if the fuel level in the tank is less than 20 liters.

Average speed of the car

The trip computer display shows the average speed of the vehicle, calculated based on the distance traveled and the time of travel since the last connection of the battery to the on-board network or since the last reset of the trip computer.

The average vehicle speed is calculated and updated every 10 s.



In the average vehicle speed indication mode, the "AV" indicator lights up on the display.