Disconnect the negative cable from the battery.
Perform the following procedure for ease of access.
Remove the air filter.
Remove the air hose.
Pic. 2.343. Removing the Throttle Position Sensor
Remove the throttle position sensor (pic. 2.343).
Make sure the throttle valve closes completely.
Install the throttle position sensor to the throttle body.
Tightening torque: 1.6 - 2.4 Nm.
Make sure the throttle moves smoothly.
Connect the throttle position sensor connector.
Verify that the throttle position sensor output voltage is (PID WDS: throttle position) – within normal limits when the damper is open or closed.
If not correct, check the throttle position sensor.