Remove the battery tray.
Remove the radiator.
Drain the oil.
Remove the power steering oil pump with the oil filter without disconnecting the hose and place it so that it does not interfere.
Remove the air conditioning compressor without disconnecting the pipes. Position the air conditioning compressor so that it is out of the way. Use a wire or rope to secure the compressor.
Remove the joint shaft from the intermediate drive shaft.
Remove the air filter, intake air duct, accelerator cable with bracket and vacuum hose.
Remove the automatic transmission filter and selector cable. (models with automatic transmission).
Remove the vacuum hose and heater hose.
Remove the clutch slave cylinder and control cable (models with manual transmission).
Remove the plastic fuel supply hose.
Disconnect the wiring harness in the engine compartment.
Remove the front pipe.
Fig. 2.89. Components of the power unit mounting on the vehicle: 1 – Engine support No.1; 2 – Engine support bracket No.1; 3 – Engine support bracket No.4 and engine support No.4; 4 – bus connecting the engine to the body ground; 5 – Engine mounting bracket No.3; 6 – engine, gearbox in block with final drive
Remove the power unit (Fig. 2.89).