Checking the connecting rod side clearance (Mazda 6 GG)

Install the connecting rod cover.

Fig. 2.169. Measuring the lateral clearance of the lower connecting rod head

Measure the side clearance of the connecting rod lower head (fig. 2.169).

If the connecting rod small end side clearance exceeds the maximum, replace the piston, piston pin, piston ring and connecting rod assembly.

Normal clearance: 0.14–0.36 mm.
Maximum clearance: 0.435 mm.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Engine repair

Measuring the radial clearance in the crankshaft main bearings
Measuring the diameters of the crankshaft journals
Measuring the crankshaft runout value
Checking the crankshaft
Checking the oil spray nozzle valve

Measuring the radial clearance of the connecting rod
Checking the cylinder head bolts
Installing main bearing caps
Installing piston rings
Piston assembly

More articles on repairing other Mazda models
Checking/adjusting valve clearance Mazda Familia 6 (1989-1994)
Piston/connecting rod assembly — installation and checking of bearing… Mazda Capella 3 (1982-1992, petrol)
Checking the connecting rod side clearance Mazda3 BK (2003-2009)
Checking the piston with connecting rod in the cylinder block assembly Mazda CX-5KE (2012-2017)
Checking and adjusting valve clearance Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)