Measuring the diameter of the camshaft journal (Mazda 6 GG)

Fig. 2.154. Measuring the camshaft journal diameter

Measure the journal diameters of the shaft in the X and Y directions at two points (A and B) as shown in Figure 2.154.

If the values are not within the norm, replace the camshaft.

Standard diameter: 24.96-24.98 mm.
Minimum diameter: 24.95 mm.

Article is available on the website [www.MazBook.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Engine repair

Checking the camshaft
Checking the valve spring
Checking and repairing the valve seat
Pressing in the valve guide bushing
Replacing the valve guide bushing

Measuring the radial clearance of the camshaft journal
Measuring the axial clearance of the camshaft journal
Checking the valve tappet
Checking the cylinder block
Checking the oil spray nozzle valve

More articles on repairing other Mazda models
Removal the camshaft drive chain Mazda Familia 5 (1985-1989)
Camshaft cover — removal and installation Mazda Capella 3 (1982-1992, petrol)
Measuring the diameter of the camshaft journal Mazda3 BK (2003-2009)
Removal and installation the camshaft position sensor Mazda CX-5KE (2012-2017)
Camshaft/Diesel Valve Drive Mechanism Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)