Checking the brake light switch (Mazda 6 GG)

Disconnect the negative battery cable.

Disconnect the brake light switch connector harness.

Fig. 6.18. Brake light switch test diagram

Check for electrical continuity between the terminals of the brake light switch connector (Fig. 6.18).

Information copied from the portal: www.MAZbook.ru

If not, replace the brake light switch.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Brake system

Checking the pedal-to-floor clearance
Adjusting the brake pedal clearance
Checking the brake pedal clearance
Adjusting the height of the brake pedal
Checking the brake pedal height

Removal and installation the brake pedal
Removal and installation the master brake cylinder
Checking the liquid level sensor
Disassembly and assembly of the master cylinder
Removal and installation the front brake disc

More articles on repairing other Mazda models
Removal and installation the brake light switch Mazda Familia 6 (1989-1994)
Low Brake Fluid Warning Light Switch — checking and replacing Mazda Capella 6 (1997-2005, petrol)
Checking the control switch for the light on the instrument panel Mazda3 BK (2003-2009)
Checking the Parking Brake Switch Mazda CX-5KE (2012-2017)
Checking the brake light Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)