Contents: Removal ⇓ Installation ⇓
Caution! For checking the brake light switch, see Chapter Electrical equipment system.
The brake light switch is located above the brake pedal on the pedal block.
Removal
A - brake light switch
B - lock nut
C - push rod
D - lock nut
1. Turn off the ignition.
2. Disconnect the plug from the brake light switch.
The article is copied from the website www.MazBook.ru
3. Loosen the lock nut and unscrew the switch.
Installation
1. Measure the height of the pedal to the floor. For the required value, see Section Technical data of the brake system.
2. If the pedal height does not meet the required value, adjust the pedal height and play in the workshop.
3. Screw in the brake light switch until it touches the pedal and then turn it another half turn. Tighten the lock nut.
4. Connect the plug and turn on the ignition.
5. Press the brake pedal, asking your assistant to watch the brake lights. They should turn on even when you press the pedal lightly, otherwise adjust the switch accordingly.