Installing the cylinder head cover (Mazda 6 GG)

Apply silicone sealant to the mating surfaces of the cylinder block in the areas shown by the arrows (Fig. 2.114).

The diameter of the application point is 4.0–6.0 mm.

Install the cylinder head cover with a new gasket.

Fig. 2.114. Places of sealant application

Fig. 2.115. Cylinder head cover fastening bolt tightening sequence

Tighten the mounting bolts in the order shown in Figure 2.115 to a tightening torque of 8–11.5 N·m.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Engine repair

Installing the crankshaft pulley mounting bolt
Installing Engine Rubber Mount #3 and Engine Mount Bracket #3
Installing the front crankshaft oil seal
Installing the front engine cover
Installing the timing chain

Removal and installation the oil control valve (OCV) (L3)
Checking the Oil Control Valve (OCV) (L3)
Checking the operation of the spool valve (OCV) (L3)
Disassembling the cylinder head
Disassembling the cylinder block

More articles on repairing other Mazda models
Installing the cylinder head Mazda Familia 5 (1985-1989)
Cylinder head cover — removal and installation Mazda Capella 3 and 4 (1982-1992)
Installing the cylinder head cover Mazda3 BK (2003-2009)
Installing the cylinder head Mazda CX-5KE (2012-2017)
Installing the cylinder head Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)