Fig. 2.86. Installing a special device on the camshaft
Install the special tool on the camshaft (see fig. 2.86).
Fig. 2.113. Crankshaft pulley lock bolt: 1 – bolt
Install the M6x1.0 lock bolt and tighten it by hand (fig. 2.113).
Turn the crankshaft clockwise to TDC of the piston of cylinder No.1.
Fig. 2.104. Installing a special device on the crankshaft: 1 - special device
Hold the crankshaft pulley with a special device (see fig. 2.104).
Tighten the crankshaft pulley mounting bolt in two steps:
tighten the bolt to 96–104 N·m;
tighten the bolt to 87-93°
Unscrew the M6x1.0 bolt.
Remove the special tool from the camshaft.
(The original text is published on: MAZbook.ru)
Remove the special tool from the hole in the lower plug of the cylinder block.
Turn the crankshaft clockwise two revolutions to TDC of the piston of cylinder No.1. If the TDC position cannot be reached, loosen the crankshaft pulley mounting bolt and repeat the described steps from the beginning.
Install the lower cylinder block plug and tighten it to a tightening torque of 18–22 N·m.