Contents: Removal ⇓ Installation ⇓
Fig. 2.277. Crankshaft pulley: 1 – crankshaft pulley mounting bolt; 2 – crankshaft pulley; 3 – front oil seal
Removal
Remove the battery cover.
Disconnect the negative cable from the battery.
Remove the drive belt.
Secure the crankshaft pulley using special tools.
Loosen the crankshaft pulley mounting bolt.
Use a knife to cut off the working edge of the seal.
Fig. 2.278. Removing the front oil seal
Remove the oil seal using a flat-head screwdriver wrapped in a rag to prevent damage to the crankshaft oil seal (fig. 2.278).
Installation
Apply clean engine oil to the front oil seal.
Insert the front oil seal into the front engine cover by hand.
Press in the front oil seal using a special tool and a hammer.
Pressing depth from the front engine cover 0–0.5 mm.
Secure the crankshaft pulley using special tools.
Tighten the crankshaft pulley mounting bolt.
Tightening torque: 157–167 Nm.