Installation of the drive disk (with automatic transmission), flywheel (with manual transmission) (Mazda 3 BK)

Install and press in the rear crankshaft oil seal.

Hold the crankshaft from turning using a special device.

Fig. 2.180. The order of tightening the flywheel or drive disk mounting bolts

Tighten the mounting bolts in the order shown in Figure 2.180 in several stages.

Install the remaining components in the reverse order of removal and disassembly of the cylinder block.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda3 BK » Engine repair (gasoline)

Assembly of the balancing unit (L3 with variable valve timing…
Installing the connecting rod bearing and cover
Piston assembly
Installing piston rings
Installing main bearing caps

Installing the oil pan
Installing the oil seal
Installing the cylinder head
Installing camshafts
Assembly of the timing mechanism drive

More articles on repairing other Mazda models
Filling automatic transmission with oil Mazda Familia 5 (1985-1989)
Manual transmission Mazda Capella 3 (1982-1992, petrol)
Installing the drive disk (with automatic transmission), flywheel… Mazda6 GG (2002-2008)
Automatic transmission shift mechanism Mazda CX-5KE (2012-2017)
Manual transmission: checking the oil level Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda3 BK (2003-2009)