Installing the drive disk (with automatic transmission), flywheel (with manual transmission) (Mazda 6 GG)

Hold the crankshaft from turning using a special device.

Fig. 2.180. The order of tightening the flywheel or drive disk mounting bolts

Tighten the mounting bolts in the order shown in Figure 2.180 in several stages.

Install the remaining components in the reverse order of removal and disassembly of the cylinder block.

(The original article is posted on MAZbook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Engine repair

Assembly of the balancing unit (L3 with variable valve timing…
Installing the connecting rod bearing and cover
Piston assembly
Installing piston rings
Installing main bearing caps

Installing the oil pan
Cylinder head assembly
Assembly of the timing mechanism drive
Technical data of the mechanical part of engines of models L8, LF, L3

More articles on repairing other Mazda models
Filling automatic transmission with oil Mazda Familia 5 (1985-1989)
Manual transmission Mazda Capella 3 (1982-1992, petrol)
Installation of the drive disk (with automatic transmission),… Mazda3 BK (2003-2009)
Automatic transmission shift mechanism Mazda CX-5KE (2012-2017)
Manual transmission: checking the oil level Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)