Loosen the locknuts on the left and right tie rod ends and turn the tie rods the same amount. Both tie rods have right-hand threads. Turn the right tie rod toward the front of the car and the left tie rod toward the rear to increase wheel alignment.
Note: Rotating both tie rods one full turn changes the toe-in by approximately 6 mm.
Tighten the tie rod end locknuts to the specified torque.
Tightening torque: 68.6–98.0 N·m.
Make sure the cover is not twisted and install the cover clamp.
Note: Adjust the toe-in after setting the camber.