Remove the front disc brake caliper.
Fig. 3.117. Removing the brake disc
Remove the brake disc (fig. 3.117).
Fig. 3.118. Checking the clearance in the rear wheel hub bearing
The original article is posted on: www.MAZbook.ru
Place a dial indicator against the wheel hub (fig. 3.118).
By moving the wheel hub manually in the axial direction, measure the clearance in the hub bearing.
Maximum: 0.05 mm.
If the clearance exceeds the maximum, replace the bearing.
Caution! Performing the following procedures without first removing the ABS wheel speed sensor may cause an open circuit in the wiring harness if the harness is accidentally tightened. Remove the ABS wheel speed sensor before performing the following procedures (from the body side) and fix it in a suitable place where the sensor will not be damaged by mistake during maintenance.