Contents: Installing wheels on a car ⇓ Removal/installing suspension arms ⇓ Disconnecting connectors ⇓ All-wheel drive control system…⇓
Installing wheels on a car
When installing wheels on a vehicle, tighten the wheel nuts in a cross pattern to a torque of 108-147 Nm.
Removal/installing suspension arms
For hinge sections with rubber bushings, it is necessary to raise the car on a lift, then tighten the mounting bolts with nuts. Lower the car to the ground and tighten to the specified tightening torque.
Disconnecting connectors
Before performing any work involving disconnecting connectors, disconnect the negative battery terminal.
All-wheel drive control system components
After servicing the components of the electronic all-wheel drive control system, make sure that there are no fault codes in the control unit memory. Clear all fault codes from the memory.