Contents: Removal ⇓ Installation ⇓
Removal
Place the car on a lift and raise the rear wheels.
Disconnect the stabilizer link pins from the front wishbones.
Remove the stabilizer bar mounting brackets from the rear suspension crossmember and remove the stabilizer bar.
Installation
Check the condition and safety of the cushions in the rod brackets. If the cushions are worn or damaged, replace them.
Install the stabilizer bar on the brackets with cushions, orienting the cuts of the cushions in the direction of the car's movement. Tighten the bracket mounting bolts and nuts.
Attach the stabilizer pins to the front wishbones and tighten the pin nuts until the threaded portion protrudes 18 mm (dimension "Y", see photo).
Lower the vehicle and tighten the stabilizer bar bracket mounting bolts to 4.4-5.5 kgf·m.