Removing
1. Disconnect the ground cable from the battery.
Attention! This erases the data from the engine fault memory or the radio's security code. Before disconnecting the battery, read the instructions in Section Removing and installing the battery.
2. Mark the position of the wipers on the glass with adhesive tape so that they can be reinstalled.
3. Unscrew the levers and remove from the axles, having previously removed the caps with a narrow screwdriver.
Installation
1. Put the levers in the final position on the wiper axle and screw firmly 15 Nm. In the final position, the wipers should be at a distance of 28-32 mm from the end surface of the decorative trim or air intake grille.
2. Install the caps on the wiper shaft.
3. Connect the mass cable to the battery.
4. Check the operation of the wipers.
5. If available, set the clock and set the radio's security code.