2. Remove the gear shift lever:
Remove the top panel.
Remove the gear shift knob.
Remove the switch panel.
Remove the side walls.
Remove the rear console.
Press the lock on the drive cable as shown in the figure and disconnect the drive cable from the shift lever.
Disconnect the drive cable end from the shift lever as shown in the illustration.
Disconnect the connector from the shift lever as shown in the figure.
Remove the shift lever.
3. Remove the gear shift drive cables:
Remove the air filter.
Remove the battery from the shelf.
Remove the drive cable end from a manual transmission:
Pull the locking pin in the direction of the arrow in the figure to release the drive cable end retainer (from the manual transmission side).
Remove the drive cable end from the manual transmission.
Press the clamps to disconnect the drive cables from the bracket.
Loosen the drive cable mounting nut.
Loosen the nuts securing the trim.
Remove the drive cables from the vehicle.
4. Make sure that the gear shift lever (from the gearbox side) is in a neutral position.
5. Installation is carried out in the reverse order of removal.