Checking the vacuum hose check valve (brake booster) (Mazda 3 BK)

Remove the clamps and vacuum hose.

Fig. 6.10. Check valve testing diagram

Apply vacuum and pressure alternately to the engine side vacuum hose and make sure that air can only flow in one direction (Fig. 6.10).

If air flows in both directions, replace the vacuum hose.

Data provided by the website: www.MAZbook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda3 BK » Brake system

Bleeding the brake system
Checking the brake fluid level in the hydraulic reservoir of the…
Checking and adjusting the brake system components
On-board diagnostics of the brake system
Controller Area Network (CAN)

Removal and installation a vacuum hose (brake booster)
Checking the brake pedal
Removal and installation the brake pedal
Removal and installation the master brake cylinder
Checking the liquid level sensor

More articles on repairing other Mazda models
Brake master cylinder and vacuum booster Mazda Familia 5 (1985-1989)
Vacuum brake booster Mazda Capella 3 and 4 (1982-1992)
Checking the vacuum hose check valve (brake booster) Mazda6 GG (2002-2008)
Checking, removing and installing the vacuum hose Mazda CX-5KE (2012-2017)
Vacuum brake booster — check Mazda BT-50 (1) (2006-2011)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda3 BK (2003-2009)