Fig. 6.11. Disconnecting the vacuum hose connector
Disconnect the vacuum hose connector from the brake booster by pressing on the tabs of the vacuum hose connector (Fig. 6.11).
Fig. 6.12. Removing the clamp
Remove the clamp using pliers and disconnect the vacuum hose from the intake manifold (Z6) (Fig. 6.12).
Fig. 6.13. Disconnecting the vacuum hose from the intake manifold
Insert a thin flat-blade screwdriver at the point indicated by the arrow in Figure 6.13, move the ring down and disconnect the vacuum hose from the intake manifold (LF).
Remove the vacuum hose.
Install in the reverse order of removal.
Make sure the vacuum hose is inserted so that the vacuum hose connection touches the intake manifold (LF) ring.
Insert the vacuum hose connector into the brake booster.
(The text of the article is taken from the website MAZBOOK.ru)
Make sure the vacuum hose is securely installed by pulling on it and reinsert it into the brake booster.
Fig. 6.14. Installing the brake booster coil
Make sure the brake booster coil is in the vacuum hose connector (Fig. 6.14).