The sequence for checking the oil level is given below
1. Place the vehicle on a level surface.
2. Unscrew the filler plug and remove the washer.
3. Make sure that the gearbox oil reaches the lower edge of the filler hole. If necessary, top up the gearbox oil to the specified level. Use the same type of oil as that in the gearbox.
- Oil quality according to API - GL-4 or GL-5.
- Oil viscosity according to SAE:
- all-season - SAE 75W-90;
- above 10°C - SAE 80W-90.
4. Install a new washer and tighten the filler plug.
- Tightening torque: 40–58 Nm.
The procedure for changing the oil in a manual transmission is described below
1. Unscrew the drain plug.
2. Drain the oil into a container.
3. Install a new washer and tighten the drain plug.
- Tightening torque: 40–58 Nm.
4. Unscrew the filler plug and remove the washer. Fill the gearbox with oil to the level of the lower edge of the filler hole.
- Oil quality according to API - GL-4 or GL-5.
- Oil viscosity according to SAE:
- all-season - SAE75W-90;
- above 10°C - SAE 80W-90.
- The volume of oil to be filled is 2.7 l.
5. Install a new washer and tighten the filler plug.