Level check
1. Install the car on a flat horizontal platform.
2. Remove the fill plug.
3. Make sure the fluid level is at the bottom edge of the filler hole.
If necessary, bring the level of the working fluid to the established norm.
- Working fluid - Mercon Multi-purpose AFT
- Catalog number (part number) — XT-2-QDX
4. Install a new washer on the plug and tighten the filler plug.
- Tightening torque - 40 - 59 Nm
Replacement
Note:
- Due to the design features of the gearbox "sensitive" to the type and quality of the working fluid used, which can manifest itself in difficult gear shifting.
- During operation, the properties of the working fluid deteriorate, which may affect the operation of the gearbox (e.g. difficult gear changes).
- Although the manufacturer's regulated fluid change interval is 100,000 km, it is recommended to change the fluid more often (after about 60000-75000 km).
1. Install the car on a flat horizontal platform.
2. Unscrew the filler and drain plugs and remove the gaskets. Drain the gearbox oil.
3. Clean the drain and fill plugs.
4. Install a new washer on the drain plug and tighten the drain plug.
- Tightening torque - 40 - 59 Nm
5. Fill in the working fluid to the level of the lower edge of the filler hole.
- Working fluid - Mercon Multi-purpose AFT
- Catalog number (part number) — XT-2-QDX
- Filling capacity - 3.55 l
6. Install a new gasket on the fill plug and tighten the fill plug.
- Tightening torque - 40 - 59 Nm