Checking the level and changing the oil in the transfer case (Mazda BT-50 (1))

Checking the level

1. Place the vehicle on a level, horizontal surface.

2. Unscrew the filler plug and remove the gasket.



3. Make sure that the working fluid level is at the lower edge of the filler hole.



If necessary, top up the working fluid level to the established norm.

• Working fluid - Mercon^® Multi-purpose AFT
• Catalogue number (part number) — XT-2-QDX

4. Install a new gasket on the filler plug and tighten the plug.

• Tightening torque - 39 - 59 Nm

Replacement

Note: Although the manufacturer's recommended replacement interval for the working fluid is 100,000 km, it is recommended to replace the fluid more frequently (approximately 60,000-75,000 km).

1. Place the vehicle on a flat, horizontal surface,

2. Remove the lower protective cover of the transfer case (see section "Gearbox assembly").

3. Unscrew the drain plug and drain the working fluid from the transfer case.



4. Install a new gasket on the drain plug and tighten the drain plug.

• Tightening torque - 39-59 Nm

5. Unscrew the filler plug and pour the working fluid into the transfer case.

• Working fluid - Mercon^® Multi-purpose AFT
• Catalogue number (part number) — XT-2-QDX
• Filling capacity - 1.85 l

6. Install a new gasket on the filler plug and tighten the filler plug.

• Tightening torque - 39-59 Nm

7. Install the lower protective cover of the transfer case (see section "Gearbox assembly").

The article is copied from the website: Mazbook.ru