- Oil filler gasket.
- Gear oil specification: temperatures above -18°C: API GL- 5 SAE 90; temperatures below -18°С: API GL-5 SAE 80.
Examination
Transfer case
1. Raise the car in a horizontal position.
2. If equipped, remove the engine and transmission shield.
3. Visually check the transfer case for tightness.
4. Remove oil filler bolt -B-.
5. Insert your finger into the hole and check the oil level. The oil level must be at the height of the filler hole. If necessary, add oil through the hole.
6. Install the oil filler bolt with a new gasket and tighten firmly 55 Nm.
7. If equipped, install the engine and gearbox shield.
8. Lower the car.
Rear differential
1. Raise the car in a horizontal position.
2. Check the tightness of the rear axle.
3. Remove oil filler plug -B-.
4. Insert your finger into the hole and check the oil level. The oil level must be at the height of the filler hole. If necessary, add oil through the hole.
5. Install the oil filler screw with new gasket and tighten firmly 55 Nm.
6. Lower the car.