- Gaskets for oil filler and oil drain plugs.
- Gear oil specification: temperatures above -18°C: API GL-5 SAE 90; temperatures below -18°С: API GL-5 SAE 80.
Replacement
Transfer case
1. Raise the car in a horizontal position.
2. If equipped, remove the engine and transmission shield.
3. Visually check the transfer case for tightness.
4. Unscrew the oil filler plug -B-.
5. Unscrew the oil drain plug -A- and drain the oil until it starts to drip. Install the oil drain plug with new gasket and tighten firmly 55Nm.
6. Fill in approximately 0.5 liters of gear oil and check the level with your finger. The level should be at the bottom edge of the filler hole.
7. Install the oil filler plug with new gasket and tighten firmly 55 Nm.
8. If equipped, install the engine and gearbox shield.
9. Lower the car.
Rear differential
1. Raise the car in a horizontal position.
2. Visually check the tightness of the rear axle.
3. Remove oil filler plug -B-.
4. Unscrew the oil drain plug -A- and drain the oil until it starts to drip. Install the oil drain plug with new gasket and tighten firmly 55 Nm.
5. Fill in approximately 0.65 liters of gear oil and check the level with your finger. The level should be at the bottom edge of the filler hole.
6. Install the oil filler plug with new gasket and tighten firmly 55 Nm.
7. Lower the car.