1. Bleed nipple cap.
2. Bleeding nipple.
3. Piston.
4. Dust cover.
5. Piston seal.
6. Caliper body.
Note:
: replace the part with a new one after each removal.
: use a special tool or device.
: apply brake fluid.
Disassemble the caliper in the sequence shown in the figure, taking into account the following:
- Using a special tool, turn the piston counterclockwise and remove it from the caliper cylinder.
Assembly is carried out in reverse order, taking into account the following:
- Install the dust cover on the piston.
- Insert the edges of the dust boot installed on the piston into the groove of the caliper, as shown in the figure.
- Slowly rotate the piston using a special tool until the piston is fully pressed into the cylinder.
- Make sure the dust boot is securely inserted into the piston groove.