Rear caliper view
1. Piston; 2. Bracket; 3. Dust seal; 4. Piston seal; 5. Retaining ring; 6. Self-adjusting parking brake axle; 7. Ring seal; 8. Stopper; 9. Communication; 10. Upper dust seal; 11. Lid; 12. Lower dust seal; 13. Return spring; 14. Parking brake cable support; 15. Spindle lever; 16. Dust seal; 17. Rubber cover; 18. Bleed nipple
1. Block the front wheels, then jack up the rear of the car and support it on axle stands.
2. Remove the rear wheel and apply the parking brake.
3. Loosen the lock nut and remove the parking brake cable housing from the caliper mount. Disconnect the inner parking brake cable from the caliper arm.
4. Install the hose clamp onto the high pressure brake line to the caliper.
5. Loosen the connecting bolt and remove the brake line from the caliper (photo). Remove the gaskets.
Rear high pressure brake line pipe of the caliper (marked with an arrow)
6. Remove the upper and lower guide pins and remove the caliper from the suspension. Remove the brake disc pads.
7. Check the guide pins and bushings for wear and damage, replace them if necessary (photo).
Removing the bushing from the rear brake caliper guide pin
8. Assembly is carried out in the reverse order, but at the same time tighten the weight of the nuts and bolts with the specified tightening force Specification, bleed the steam line as described in Section 9. Depress the brake pedal several times after reinstalling the brake disc pad.
Article is available on the website mazbook.ru