MAZDA 323 since 10/89
Removal
1. Remove the door trim.
2. Disconnect the multi-pin plug, for example for the window lift motor, electrically adjustable mirror, central locking device.
3. Knock out pin "2" on the door latch upwards using a hammer and punch.
The article is reprinted from the portal [MazBook]
4. Unscrew the bolts on the door hinges. Mark the installation position in advance by tracing the bolt heads with a felt-tip pen. Remove the door with the help of an assistant.
Installation
1. Insert, align and screw the door.
Attention! If the door needs to be re-aligned, the lock must first be removed.
2. Insert the door brake pin from above.
3. Connect the electrical plugs and install the door trim.
4. If necessary, adjust the door.
5. Install the door lock.
Door adjustment
1. The door needs to be adjusted if it does not close properly even after it has been removed.
2. Loosen the door wedge enough to be able to move it with blows from a rubber mallet. To do this, you will need a Phillips screwdriver or a screwdriver for internal TORX bolts.