Removing
1. Disconnect the ground cable from the battery.
Attention! This erases the data from the engine fault memory or the radio's security code. Before disconnecting the battery, read the instructions in Section Removing and installing the battery.
2. Disconnect the fan plug.
3. To unscrew bolts of fastening of the holder of the fan on a radiator.
4. Tilt the fan motor with holder back and pull it out.
5. While holding the impeller, unscrew the central fan screw on the motor.
6. Unscrew the mounting bolts and remove the motor from the holder.
Installation
1. Screw the fan motor to the holder.
2. Screw the impeller to the motor.
fan motor
3. Screw the motor with holder to the radiator with force 10 Nm.
4. Connect the plug.
5. Connect the battery ground cable.
6. If available, set the clock and set the radio security code.
7. Check work. To do this, warm up the engine so that the fan turns on.