1. Unscrew the oil filter. The oil filter is located, looking in the direction of travel, at the back of the cylinder block. There is a special tool for unscrewing the filter, for example, HAZET 2172. You can also hammer a sharp screwdriver into the filter from the side. Oil will leak out - place a container underneath.
2. Clean the oil filter flange on the cylinder block with fuel. Remove the filter gasket.
3. Lightly coat the rubber gasket on the filter with engine oil.
1. Gasoline engine: Screw the new filter on by hand. When the filter gasket is flush with the cylinder block, tighten the filter an additional 1/2 turn. Follow the instructions on the filter.
Please note: Only filters intended for this model may be used.
1. Diesel engine: Screw the filter on by hand until the gasket is flush with the oil cooler. Then tighten the filter with the tightening band 7/8 of a turn. Follow the instructions on the filter.
Please note: Only filters intended for this model may be used.