Contents: Self-adhesive balance weights…⇓ Stuffed Balance Weights (internal) ⇓ Confirmatory balancing of the…⇓
Attention.
- Adjust the imbalance first on the outside of the wheel, then on the inside.
- Be careful not to scratch the wheel rim.
Self-adhesive balance weights (external)
1. Remove the old balance weight from the wheel.
2. Remove any remaining double-sided tape from the wheel rim, clean and degrease the area where the weight is attached.
3. Install the wheel on the balance stand, measure the imbalance value and the position of the fixed balance weight in the installation mode.
4. Multiply the imbalance value by 1.6 to obtain the balance weight value.
5. Select a balance weight with a mass closest to the calculated value and install the weight (outside) in the position indicated by the stand.
Example of calculating the mass of a balance weight:
[The article is copied from the website: MAZBOOK.ru]
- Displayed imbalance value: 23g
- 23 g x 1.6 = 36.8 g
- Weight of the selected balance weight: 35 g.
Note: When selecting a balance weight, choose the value closest to the calculated one. For example: 32.4 g = 30 g.
Attention.
- Use original balance weights or equivalent (steel).
- When attaching the weight, press it with a force of 25 N for every 5 g of mass for two seconds or longer.
6. If two balance weights are connected, place them one after the other on both sides of the position marked by the balance stand.
Attention.
- Do not install balance weights in a row.
- Do not install balance weights overlapping each other.
- The total weight of the balance weights must not exceed 160 g.
Stuffed Balance Weights (internal)
1. Using a balancing stand, measure the amount of imbalance.
2. Install the weight corresponding to the measured value in the position (from the inside) indicated by the balancing stand.
Attention.
- Do not install three or more balance weights.
- The mass of one balance weight must not exceed 60 g, and the total mass of two balance weights must not exceed 100 g.
Confirmatory balancing of the residual value
1. After installing the outer and inner weights, turn on the balancing stand again.
2. Make sure that the residual imbalance does not exceed the following values on both sides. If the residual imbalance is not within the standard, balance the wheel again.
