Removal and installation the fuel pressure sensor
Note:
- The fuel pressure sensor cannot be replaced separately.
- If it is necessary to replace the fuel pressure sensor, it must be replaced together with the fuel rail.
Checking voltage
1. Connect the M-MDS device to the DLC-2 diagnostic connector.
2. Turn on the ignition (engine off or on).
The text of the article is taken from the website (Mazbook.ru)
3. Make sure that the output voltage of the fuel pressure sensor (FUEL_PRES by M-MDS device) corresponds to the norm. If the obtained value does not correspond to the norm, replace the fuel rail with a new one.
