Removal and installation the accelerator pedal position sensor
Note: Since the accelerator pedal position sensor is built into the accelerator pedal, it is not possible to replace the sensor separately.
Checking the accelerator pedal position sensor
Checking voltage
1. Connect the M-MDS device to the DLC-2 diagnostic connector.
2. Turn on the ignition (engine off or on).
(The original text is published on Mazbook.ru)
3. Make sure that the output voltage (APP1, APP2 according to M-MDS device) increases according to the increase in the throttle opening angle with a smooth increase in the opening angle. If the output voltage changes, go to the next step. If the output voltage does not change, replace the accelerator pedal with a new one.
4. Make sure that the output voltage of the throttle position sensor (APP1, APP2 according to M-MDS device) corresponds to the norm with the pedal pressed and released. If the obtained values do not correspond to the norm, replace the accelerator pedal with a new one.
