1. Rear crankshaft oil seal.
1. Remove the gearbox from the engine.
2. Remove the flywheel (manual transmission) or drive disk (automatic transmission).
3. Cut off the edges of the seal using a regular knife.
4. Remove the oil seal using a flat-head screwdriver wrapped in a clean cloth to avoid damaging the crankshaft surface.
5. Apply clean engine oil to the inside surfaces of the new crankshaft rear oil seal.
6. Manually insert the rear crankshaft oil seal into the front engine cover.
7. Press the seal evenly using a mandrel and a hammer.
Note: Pressing depth of rear crankshaft oil seal: 0-0.5 mm.
