Familia Capella Mazda3 Mazda6 CX-? Others Articles

CX-5KE (2012-2017)

Checking the all-wheel drive solenoid (Mazda CX-5KE)

0

1. Disconnect the negative battery terminal.

2. Disconnect the all-wheel drive solenoid connector.

3. Measure the resistance between terminals A and B of the all-wheel drive solenoid connector. If the measured resistance value is not within the standard (2.2-2.7 ohms at a rear final drive oil temperature of 20°C), replace the coupling.

3. Measure the resistance between terminals A and B of the all-wheel drive solenoid connector. If…

4. Connect the 4WD solenoid connector.

5. Connect the negative battery terminal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evgeny Mereshnikov

Share with friends on social networks:

Previous

CX-5KE » Drive shafts and cardan

Next

Rear Final Drive Oil Temperature Sensor
Removal and installation the coupling
Assembling the rear final drive
Disassembling the rear final drive
Removal and installation the rear final drive assembly

Checking the all-wheel drive control unit
Removal and installation the all-wheel drive control unit
Special tools and accessories

More articles on repairing other Mazda models
Detailed technical specifications of the wheel drive Mazda Familia 5 (1985-1989)
Power steering with 4-wheel drive (4WS) Mazda Capella 3 (1982-1992, petrol)
Checking the accessory drive belt Mazda3 BK (2003-2009)
Folding the rear seat on all-wheel drive station wagons Mazda6 GG (2002-2008)
Checking the all-wheel drive engagement sensor Mazda BT-50 (1) (2006-2011)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

CX-5KE (2012-2017)

By continuing to use the site, you agree to the use of cookies 🔐