MazBook.ru
English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
• Bookmark • Sitemap • Contacts •   
Cars Opel Cars Ford Cars Volkswagen Cars Audi Cars Kia Cars Renault Cars Peugeot
 
 
 
 
 
 
 
Familia Capella Mazda3 Mazda6 CX-? Others Articles
CX-5KE (2012-2017)

Checking the intake system components (Mazda CX-5KE)

  • Home
  • Mazda CX-?
  • CX 5 KE (2012-2017)
  • Power unit
  • Intake and exhaust system
  • Checking the intake system components
0
Contents: Checking the air filter element ⇓ Checking the throttle body (gasoline…⇓ Checking the check valve ⇓ Checking the air-to-air intercooler…⇓

Checking the air filter element



1. Remove the air filter element.

2. Check the following:
  • When was the filter element last replaced?
  • Is the filter element dirty, damaged or deformed?
  • Is the air filter housing sealed sufficiently?
  • Is the air filter element installed correctly?

3. If any defects are found, replace the air filter element with a new one.

Checking the throttle body (gasoline engine)



1. Disconnect the negative battery terminal.

2. Disconnect the throttle body connector.

3. Measure the resistance between terminals E and F of the throttle body connector.

3. Measure the resistance between terminals E and F of the throttle body connector.


Note: Throttle body resistance: 1.38 ohms.


4. If the measured value is not within the standard, replace the throttle body with a new one.

Checking the check valve



Checking the air flow



1. Remove the vacuum hose.

2. Blow into the vacuum hose from the vacuum pump side with your mouth and make sure that air comes out from the intake manifold side. Then blow from the intake manifold side and make sure that air does not come out from the vacuum pump side.



Check valve

Check valve


Diesel Engine Check Valve

Diesel Engine Check Valve


3. If the check valve is faulty, replace it together with the vacuum hose (gasoline engine) or separately (diesel engine).

Checking the air-to-air intercooler (diesel engine)



1. Remove the air-to-air intercooler (intercooler) from the car.

2. Seal port A.

2. Seal port A.


3. Apply compressed air through port B and check the tightness of the intercooler. If air leaks are detected through the intercooler, replace it with a new one.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This text was checked by: Evgeny Mereshnikov
Share with friends on social networks:

Previous
CX-5KE » Intake and exhaust system
Next

Removal and installation of the intercooler of the air intake system…
Removal and installation of diesel engine intake system components
Diesel Engine Intake System Vacuum Hose Routing Diagram
Removal and installation of components of the intake system of a…
Checking the vacuum in the intake manifold of a gasoline engine
Checking the exhaust system
Exhaust system of gasoline engines
Diesel engine exhaust system
More articles on repairing other Mazda models
Checking and adjusting the injection system Mazda Familia 5 (1985-1989)
Checking, removing and installing electronic control system… Mazda Capella 3 and 4 (1982-1992)
Intake system components (diesel) Mazda3 BK (2003-2009)
Checking and adjusting the brake system components Mazda6 GG (2002-2008)
Checking the cooling system for tightness Mazda 121 (3) (1996-2003)
Link in different formats to this article
Comments and feedback from visitors
No comments yet


How much will 42 + 21 ?

       



CX-5KE (2012-2017) 
  • General information
  • Introduction to the guide
  • User manual
  • Maintenance
  • Power unit
  • Petrol engines 2.0 l
  • Petrol engines 2.5 l
  • Diesel engines 2.2 l
  • Cooling system
  • Lubrication system
  • Supply system
  • Control system
  • Intake and exhaust system
  • Engine electrical equipment
  • Transmission
  • Clutch
  • Mechanical gearbox
  • Automatic gearbox
  • Transfer case
  • Drive shafts and cardan
  • Chassis
  • Wheels and tires
  • Front suspension
  • Rear suspension
  • Brake system
  • Steering
  • Body
  • Exterior (external elements)
  • Interior (internal elements)
  • Security systems
  • Heating and air conditioning
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
MazBook.ru © 2018–2026 · Mobile version · Articles and news · Sitemap: EN BG BY UA RS HR RO PL SK HU · Feedback · Site search · Add to bookmarks Familia 5 (BF) · Familia 6 (BG) · Capella 3 (GC) · Capella 3 and 4 (GC) · Capella 4 (GD) · Capella 5 (GE) · Capella 6 (GF) · Mazda3 BK · Mazda6 GG · CX-5KE · Mazda 121 (3) · Mazda BT-50 (1) ·
By continuing to use the site, you agree to the use of cookies 🔐