Checking the continuity of the M position sensor circuit
Note: The M position sensor is built into the selector lever assembly.
1. Disconnect the negative battery terminal.
2. Remove the front console.
3. Disconnect the selector lever connector.
4. Check the continuity between terminals E and J of the selector lever connector. If the check results are not normal, replace the selector lever with a new one.
 |
 |
Removal and installation the position sensor
(Article is available on the website: «MAZBOOK»)
Note: The M position sensor is built into the selector lever assembly.
If it is necessary to replace the M position sensor, replace the selector lever assembly.