2. Remove the front console.
3. Disconnect the selector lever connector.
4. Remove the selector drive cable (see above).
5. Loosen the selector lever mounting nuts.
6. Remove the selector lever knob.
(The article is based on website data MAZbook.ru)
7. Remove the selector lever.
8. Installation is carried out in the reverse order of removal.
Checking the selector lever
1. Turn on the ignition (engine off or on).
2. Make sure that the selector lever moves as shown in the figure.
3. Make sure that the selector lever moves smoothly and clearly.
4. If any faults are detected, adjust the selector drive cable.