- airbag system with gas generators;
- electrical system with shock sensors and a fault diagnosis module.
Pic. 7.99. Mazda 6 passive safety system: 1 – a control lamp of airbags; 2 - spring; 3 – driver's airbag module; 4 - passenger airbag module; 5 – collision zone sensor; 6 - SAS block; 7 – a control lamp of switching off of an inflatable pillow of safety of the passenger; 8 – the gauge of a lateral pillow of safety; 9 - seat belt with pretensioner; 10 - side airbag module; 11 - seat occupancy sensor; 12 - curtain airbag module
Airbags are installed on the car in the following places: steering wheel hub, front panel (on the right side), front seat backs (from the side of the door), front and rear pillars of the body, as well as along the edge of the ceiling above the openings of the side doors. Airbags and inflatable curtains are installed discreetly and are not visible until they are deployed (pic. 7.99 and 7.100).
Pic. 7.100. Wiring diagram of the passive safety system: 1 - SAS block; 2 - seat occupancy sensor; 3 – bad contact detector; 4 – collision zone sensor; 5 - twisted pair; 6 – communication channel connector; 7 – a combination of devices; 8 – a control lamp of airbags; 9 – a control lamp of switching off of an inflatable safety cushion of the passenger; 10 - driver's airbag sensor; 11 - passenger airbag sensor; 12 - spring; 13 - supercharger No. 1; 14 - supercharger No. 2; 15 - driver airbag module; 16 - passenger airbag module; 17 - seat belt with driver pretensioner; 18 - driver curtain module; 19 – the module of a lateral pillow of safety of the driver; 20 - seat belt with passenger pretensioner; 21 - passenger curtain module; 22 - passenger side airbag module