2. Remove the fasteners.
3. Move the mudguard aside.
4. Disconnect the brake line from the left front brake hose.
5. Remove the clamp.
6. Remove the left front brake hose from the bracket.
7. Disconnect the brake line from the holder.
8. Install the special equipment on the brake pipe as shown in the figure.
9. Remove air from the brake line and special equipment.
The article is based on website data: MAZBOOK
Note: Remove air from the special equipment through connection A.
10. Connect the M-MDS device to the DLC-2 diagnostic connector.
11. Select the parameter "BRK_F_P_R".
12. Start the engine.
13. Press the brake pedal and make sure that the brake fluid pressure values on the special equipment pressure gauge and on the M-MDS display are equal. If the pressure values differ, replace the DSC electronic control unit with a new one.
14. After checking, remove the special equipment, install the brake hose, clamp and brake pipe in their places, and then remove air from the brake system.