From the gearbox side
1. Remove the front protective tray No.2.
2. Drain the automatic transmission fluid.
3. Disconnect the left front drive shaft from the gearbox.
Caution. The seal can be easily damaged by the sharp edges of the drive shaft splines. Do not allow the splines to come into contact with the seal.
4. Remove the seal using a flat-head screwdriver.
5. Using a suitable mandrel and hammer, press the new seal evenly until the mandrel contacts the seal (49 U027 003) with gearbox housing.
6. Apply automatic transmission fluid to the seal lips.
7. Install the left front drive shaft to the gearbox.
8. Fill the automatic transmission with working fluid.
9. Install front protective tray No.2.
10. Check the mechanical part of the automatic transmission.
From the torque converter housing side
1. Remove the front protective tray No.2.
2. Drain the automatic transmission fluid.
3. Disconnect the right front drive shaft.
Caution. The seal can be easily damaged by the sharp edges of the drive shaft splines. Do not allow the splines to come into contact with the seal.
4. Remove the seal using a flat-head screwdriver.
5. Using a suitable mandrel and hammer, press the new seal evenly until the mandrel contacts the seal (49 U027 003) with gearbox housing.
6. Apply automatic transmission fluid to the seal lips.
7. Install the right front drive shaft to the gearbox.
8. Fill the automatic transmission with working fluid.
9. Install front protective tray No.2.
10. Check the mechanical part of the automatic transmission.
From the torque converter housing side (FW6AX-EL)
1. Remove the front protective tray No.2.
2. Drain the automatic transmission fluid.
3. Remove the transfer case.
Caution. The seal can be easily damaged by the sharp edges of the drive shaft splines. Do not allow the splines to come into contact with the seal.
4. Remove the seal using a flat-head screwdriver.
5. Using a suitable mandrel and hammer, press the new seal evenly until the mandrel contacts the seal (49 U027 003) with gearbox housing.
6. Apply automatic transmission fluid to the seal lips.
(The original text can be found on: «www.MazBook.ru»)
7. Install the transfer case.
8. Fill the automatic transmission with working fluid.
9. Install front protective tray No.2.
10. Check the mechanical part of the automatic transmission.